Low compression mods
#1
Low compression mods
Alright so I'm shooting for a pretty high boost build and so I got to thinking about how I could lower my compression right? So I did some reading and found out about boring the block and such, but unfortunately I cannot afford such things, so I took my own DIY approach! Pics attached
I figured, adding extra grooves and such would increase surface area, lowering compression. How do y'all think I did? How much psis do you think I can run with this engine?
I figured, adding extra grooves and such would increase surface area, lowering compression. How do y'all think I did? How much psis do you think I can run with this engine?
Thread
Thread Starter
Forum
Replies
Last Post
rharris19
General Miata Chat
24
11-18-2009 12:30 AM