Manley rod little end bushing
Anyone out there have a clue what the dimensions are for the Manley rod small end bushing? Believe it or not, I called (and ordered) replacement bushings from Manley, and they said this part (14011-4) is a custom run and "they did not have the part in their catalog". Therefore they are asking me to press out the bushing (which I did) and measure it. Then they'll turn a set for me. $8.60/each, so very nice of them to do so.
The problem is, the OD I'm measuring is slightly out of round. I'm getting 0.905-0.9064". No bueno. And if you look at their website, a common size is 0.904". Which is confusing. No way do I want to be responsible for measuring this and get it wrong... ugh. |
TSE sell them so I'd guess Sav will be able to help out.
|
Can you get a better reading on the small end of the rod than the bushing itself?
|
my dial bore gauge only goes down to 1.4". And snap gauges are nearly worthless.
Perhaps Savington will know the answer. |
Measure wristpin and then ID of rod? Subtract for clearance
|
From when I had to get one (Summit added that item to their system for me) :
Summit # MAN-42041S-1 Rod End .907 Bore .23m 42041S-1 .910" OD .775" ID .975" Length - Need to cut down to .870" |
Ryan - It is the OD of the bushing that is the problem.
KY - That's it!! So I can only guess that 0.910" OD will crush into the rod small end. 42041S-1 is out of the Manley catalog and I'll just order direct from them. Thanks a million! |
I tried to order from Manley, and they pushed me to Summit.
|
All times are GMT -4. The time now is 05:32 PM. |
© 2024 MH Sub I, LLC dba Internet Brands