Mudflap

Anyone out there have a clue what the dimensions are for the Manley rod small end bushing? Believe it or not, I called (and ordered) replacement bushings from Manley, and they said this part (14011-4) is a custom run and "they did not have the part in their catalog". Therefore they are asking me to press out the bushing (which I did) and measure it. Then they'll turn a set for me. $8.60/each, so very nice of them to do so.

The problem is, the OD I'm measuring is slightly out of round. I'm getting 0.905-0.9064". No bueno. And if you look at their website, a common size is 0.904". Which is confusing.

No way do I want to be responsible for measuring this and get it wrong... ugh.

rrjwilson

TSE sell them so I'd guess Sav will be able to help out.

Supe

Can you get a better reading on the small end of the rod than the bushing itself?

Mudflap

my dial bore gauge only goes down to 1.4". And snap gauges are nearly worthless.

Perhaps Savington will know the answer.

ryansmoneypit

iTrader: (6)

Measure wristpin and then ID of rod? Subtract for clearance

KYWalker

From when I had to get one (Summit added that item to their system for me) :

Summit # MAN-42041S-1

Rod End .907 Bore .23m

42041S-1
.910" OD
.775" ID
.975" Length - Need to cut down to .870"

Mudflap

Ryan - It is the OD of the bushing that is the problem.

KY - That's it!! So I can only guess that 0.910" OD will crush into the rod small end. 42041S-1 is out of the Manley catalog and I'll just order direct from them.

Thanks a million!

KYWalker

I tried to order from Manley, and they pushed me to Summit.