Bamabat

I am just looking for opinions on an oil pump question I am having. I am not currently running a turbo but my engine is out and I am preparing to add one perhaps in six months. I'm doing all the prep work now to save hassle later and I am at the oil pump. I purchased a BE oil pump with two washers pushing 72 psi at the pump. I know I can take washer out or add them later but I really am trying to avoid pulling the motor again for final turbo install. Planning on installing a Garrett GT2860 and target 300 hp. Do you think I will run into problems using this setup for six months before I add my turbo setup without some type of oil restrictor or other parasitic drain on the oil system? Thanks for the feedback.

shuiend

iTrader: (24)

No.

sixshooter

iTrader: (12)

It will be fine. But it doesn't need any shims.