R35 coil-on-plug stalk lengths
#1
R35 coil-on-plug stalk lengths
Getting these R35 coils fitted to my VVT engine i cut a basic-bitch plate before my 3d printed mockup is complete. The only thing i need to figure out from here is getting the correct coil stalk lengths. Someone here on MT.net had a PDF from a supplier that i stupidly didn't save. Just need to find out what other coil stalks fit the VR38 coils so i can get the right length. Anyone?
#2
I believe techsalvager used NC miata plug stalks on his R35 coils on a VVT valve cover. The separate parts of the plug boots should be interchangeable. I think he said he didn't even need a hold down plate since they were so snug
I'm using 2001 pathfinder spark plug stalks on mine, but I'm also not VVT and am using a 1/4 hold down plate
I'm using 2001 pathfinder spark plug stalks on mine, but I'm also not VVT and am using a 1/4 hold down plate
#5
You can use these and cut to length https://platinumracingproductsusa.co...al-coil-stalks
Thread
Thread Starter
Forum
Replies
Last Post
chance91
DIY Turbo Discussion
9
08-27-2012 01:26 PM