Shitty Connectors causing problems
 

Ran into a strange problem on an NB. The Engine Temperature Sensor was kicking out a P0118 randomly and replacing the sensor didn't help.

Turns out that the three connectors that are mounted on the plate in the front of the engine are prone to getting wet and allowing water to get down into the connectors. One set of male and female inside the larger connector of the three had enough corrosion on the interface to cause random disconnect and a low and high resistance connection. Cleaning with a tiny file corrected the problem.

Just a suggestion:)

if you need a spare set of those, lmk

Thanks, I'm good.

Coat them in dielectric grease once you clean them up. Will help keep them from corroding again.

Water seems to set on top of mail connector and work its way inside. Going to seal that area also on all three.