msmola2002

So, I acquired a Supermiata damper for my shitbox.

I plan or grabbing a 36-2 trigger wheel

Does anybody know the size of the fasteners required?

Emilio posted for torks in another thread
I spent time googling but no luck

But I will obviously need to chase down fasteners

thanks!

stevos555

https://www.advanced-autosports.com/...nkshaft-pulley

Midtenn

iTrader: (15)

Wrong bolts. The SPM damper is interference fit onto the crank shaft using the crank bolt. I believe he's looking for the small SHCS's that secure the trigger wheel to the back of the pulley.

msmola2002

Middtenn is on teh money - this sucker is held in by friction and the crank bolt. I need the hardware to attach the trigger wheel. The little guys pictured above. I saw in another post EO2K found he needed a 7/64 bit to drive the screws so also a notmetric size to make things more fun.

I kind of expected that I would need to contact supermiata for this info (I need to order the trigger wheel anyways) but if i can get it in a public thread for future reference, that is a good repository for that info; for the community.

concealer404

iTrader: (3)

Or just get out the tap set.

msmola2002

I will drill and retap some time in September when they arrive.

shuiend

iTrader: (24)

Let me try to check the size of those bolts. I would be surprised if SPM does not sell them. I can say they are 7/64 standard Allen key.

msmola2002

Thanks to everyone who has contacted me with helpful info

I emailed supermiata

the hardware is this

https://www.mcmaster.com/91251A146/

6-32, 3/8"