|
I've got some CAT rods off ebay. The small end size that they had listed was incorrect for some reason. I measured both ends and they are factory spec.
|
Whats the thought on rod bolts? are the ARP 8740s good enough if you're aiming for under 400whp or is it worth it to go to the 2000s?
|
From what I read, the 2000's are only needed for over 200hp per cylinder.
I think they'll be fine.:D |
That's a deal if they continue to hold up.
|
Originally Posted by buffon01
(Post 799665)
I believe the 94 motors have 8.8:1. The 95-97 have 9.0:1. Then the 99-00 have 9.5:1. I also recalled reading somewhere that the automatics have lower comp ratio than the manuals. I believe all the comps ratios are manual.
|
Originally Posted by Braineack
(Post 800071)
(Sent from phone via capitalism)
There's a low comppression 94 piston iirc. Wasn't published but its know lore that was lowest compression year. Bob |
Somewhere in '95 the pistons went from slightly dished to slightly domed. The domed piston has superseded the dished piston from Mazda, so if you order pistons from Mazda Motorsports, you will get the domed piston.
|
| All times are GMT -4. The time now is 05:14 AM. |
© 2024 MH Sub I, LLC dba Internet Brands