Valve lash
#1
Valve lash
Assembling my 2004 head i checked the clearance between the (solid) valve lifters and the cam lobes. I did so because I could recall a
about adjusting valve lash.
Now all lifters on the intake cam side had a clearance of 0.09 mm or 0.0035". All 8 of them did not clear the 0.10 mm or 0.004". Now I believe the clearance should be between 0.20 - 0.23 mm or 0.008" - 0.009". Head seemed stock when I disassembled it.
Now I did lap the valves and upgrade the springs to the volvo 418737 valve springs but that's it. Other than that the head is stock.
Could any of the above have caused clearance differences this much? Or is it supposed to be that way? I feel like I should get smaller shims although the clearance is exactly the same across the board. I had to cut it short so will be installing exhaust cam tomorrow and check those clearances as well.
Thnx
Ramon
Now all lifters on the intake cam side had a clearance of 0.09 mm or 0.0035". All 8 of them did not clear the 0.10 mm or 0.004". Now I believe the clearance should be between 0.20 - 0.23 mm or 0.008" - 0.009". Head seemed stock when I disassembled it.
Now I did lap the valves and upgrade the springs to the volvo 418737 valve springs but that's it. Other than that the head is stock.
Could any of the above have caused clearance differences this much? Or is it supposed to be that way? I feel like I should get smaller shims although the clearance is exactly the same across the board. I had to cut it short so will be installing exhaust cam tomorrow and check those clearances as well.
Thnx
Ramon
Thread
Thread Starter
Forum
Replies
Last Post
thesnowboarder
Engine Performance
25
12-19-2009 02:57 PM