vvt in to 90. Check list.
 

I have searched and think I have a complete list.
Here goes did I miss anything?
1.8 01-05 engine
1.8 motorbrackets 94-05
fuel rail from a 99-00 with 1.6 regulator attached and inlet bent to clear and a little clearancing maybe.
a adapter to use 1.6 Tb or Standalone ecu to read 01-05 TB
a block off plate for egr
wire to extend cas harness
long nose crank pulley
1.6 clutch can be reused if it will hold the power and is lighter for less rotating mass(some one told me this can any one confirm)
A way to mount the stock coil, Custom I guess since the flyn miata one will not fit this engine. Any one got pics or ideas on this? Should I just mod Megasquirt to run 01-05 coils.
New begi turbo manifold for 1.8
Re used 2560
Reused 1.6 downpipe and exhaust (Is this possible)
Reused 1.6 front and rear coolant necks
DIYauto tune VVT controler
New oil pan gasket for after I dill and tap oil pan to reuse drain from 1.6 pan
New oil outlet flanges to get oil pressure to turbo using port for oil pressure switch
Longer braided oil line to run from flanges to turbo


Please review and let me know if I missed something.

I am concerned about

reusing waternecks/ getting water in and out of turbo and engine.

Choosing the right parts to get oil from engine to turbo

Custom making something to hold coils or rewiring to use vvt engine coils.

and my ability to pull this off.

We have an oil pan gasket? I thought it was just RTV, because thats cheaper for the robot in the factory to apply.

MS3x

The two half-moon thingies (front and rear of crank) can be bought new, the rest is grey goo.

so 1,6 water necks will bolt to 1.8 and provided ports needed for turbo cooling?