vvt in to 90. Check list.
#1
Senior Member
Thread Starter
iTrader: (3)
Join Date: Sep 2011
Location: Plano TX
Posts: 595
Total Cats: -1
vvt in to 90. Check list.
I have searched and think I have a complete list.
Here goes did I miss anything?
1.8 01-05 engine
1.8 motorbrackets 94-05
fuel rail from a 99-00 with 1.6 regulator attached and inlet bent to clear and a little clearancing maybe.
a adapter to use 1.6 Tb or Standalone ecu to read 01-05 TB
a block off plate for egr
wire to extend cas harness
long nose crank pulley
1.6 clutch can be reused if it will hold the power and is lighter for less rotating mass(some one told me this can any one confirm)
A way to mount the stock coil, Custom I guess since the flyn miata one will not fit this engine. Any one got pics or ideas on this? Should I just mod Megasquirt to run 01-05 coils.
New begi turbo manifold for 1.8
Re used 2560
Reused 1.6 downpipe and exhaust (Is this possible)
Reused 1.6 front and rear coolant necks
DIYauto tune VVT controler
New oil pan gasket for after I dill and tap oil pan to reuse drain from 1.6 pan
New oil outlet flanges to get oil pressure to turbo using port for oil pressure switch
Longer braided oil line to run from flanges to turbo
Please review and let me know if I missed something.
I am concerned about
reusing waternecks/ getting water in and out of turbo and engine.
Choosing the right parts to get oil from engine to turbo
Custom making something to hold coils or rewiring to use vvt engine coils.
and my ability to pull this off.
Here goes did I miss anything?
1.8 01-05 engine
1.8 motorbrackets 94-05
fuel rail from a 99-00 with 1.6 regulator attached and inlet bent to clear and a little clearancing maybe.
a adapter to use 1.6 Tb or Standalone ecu to read 01-05 TB
a block off plate for egr
wire to extend cas harness
long nose crank pulley
1.6 clutch can be reused if it will hold the power and is lighter for less rotating mass(some one told me this can any one confirm)
A way to mount the stock coil, Custom I guess since the flyn miata one will not fit this engine. Any one got pics or ideas on this? Should I just mod Megasquirt to run 01-05 coils.
New begi turbo manifold for 1.8
Re used 2560
Reused 1.6 downpipe and exhaust (Is this possible)
Reused 1.6 front and rear coolant necks
DIYauto tune VVT controler
New oil pan gasket for after I dill and tap oil pan to reuse drain from 1.6 pan
New oil outlet flanges to get oil pressure to turbo using port for oil pressure switch
Longer braided oil line to run from flanges to turbo
Please review and let me know if I missed something.
I am concerned about
reusing waternecks/ getting water in and out of turbo and engine.
Choosing the right parts to get oil from engine to turbo
Custom making something to hold coils or rewiring to use vvt engine coils.
and my ability to pull this off.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM