Miata Turbo Forum - Boost cars, acquire cats.
Share Your Pictures with Our Community. Upload Now
0 2025/12/30 23:19:22
0 2025/12/30 23:19:18
0 2025/12/30 23:19:15
0 2025/12/30 23:18:42
0 2025/12/30 23:18:04
0 2025/12/30 23:18:01
0 2025/12/30 23:17:57
0 2025/12/30 23:16:57
0 2025/12/30 23:16:53
0 2025/12/30 23:16:50
0 2025/12/30 23:16:46
0 2025/12/30 23:16:42
Advertisement
0 2025/12/30 23:15:57
0 2025/12/30 23:15:40
0 2025/12/30 23:15:23
0 2025/12/30 23:15:19
0 2025/12/30 23:15:15
The flap hits so I clearanced it. The actuator doesn't have enough stroke but I'm keeping my options open. pun intended.
The flap hits so I clearanced it. The actuator doesn't have enough stroke but I'm keeping my options open. pun intended.
0 2025/12/30 19:36:48
Rounded and enlarged. All the work had to be done through the inlet. I used a small right angle grinder and a good 3/8" round end bit. I only enlarged it about 2-3mm.
Rounded and enlarged. All the work had to be done through the inlet. I used a small right angle grinder and a good 3/8" round end bit. I only enlarged it about 2-3mm.
0 2025/12/30 19:36:47
0 2025/12/30 19:36:46
0 2025/12/30 19:36:45
These turbos are already ported really well to direct the exhaust flow. But I see that ledge could be rounded off and get a little bigger on the diameter.
These turbos are already ported really well to direct the exhaust flow. But I see that ledge could be rounded off and get a little bigger on the diameter.
0 2025/12/30 19:36:44
0 2025/12/30 19:36:42
0 2025/12/30 16:14:52
0 2025/12/30 15:14:41
0 2025/12/30 15:14:37
0 2025/12/30 15:06:45
0 2025/12/30 15:06:37
0 2025/12/30 15:06:34
0 2025/12/29 20:33:58
0 2025/12/29 18:52:58
0 2025/12/29 18:08:18
Advertisement