90 Ecu
 

where is the ecu in a 1990 miata? is it under the dash and is it hard to get to? also do i have to drop my tank to put my walbro fuel pump in?

under the passenger feet, pull the carpet up and take off a few 12mm (maybe 10mm) nuts.

no, read my projects link for instructions. it's about a 15-30min job.

Brain's pointed it out....

Panel on the rear parcel shelf allows you access to the fuel pump....

ECU for the 90's is under pax floor panel under dash....

That said.... you should consider finding a workshop manual, it will help you find these things in future, and give you the right "process" for troubleshooting etc......

Dave,

is there a pax floor on the rear shelf for the fuel pump to cause i took out the push clips for the carpet and pulled that back and its all isolation

Pull up the insulation and remove the plate behind the driver seat(USA Model)

read Sam's writeup:

https://www.miataturbo.net/forums/at...1&d=1158700262

yea i know but the isolation is like stuck on there and then theres like a big metal plate like the one over the ecu thats what i dont get

yeah gotta watch out for that isolation. it's a bitch.

rip that junx up, and unscrew the panel. unplug the wires and hoses, unscrew the pump, rip it off, cut the tube, fit the new one, clamp the hose, reinstall.

yea i guess haha thanks guys

one more question what panel is the pump under..

https://www.miataturbo.net/forums/at...0&d=1158700256

https://www.miataturbo.net/forums/at...1&d=1158700262

its the panel with the return and feed line and electrical connection.

https://www.miataturbo.net/forums/at...3&d=1158700274

uhm, isn't there only ONE :gtfo:

another problem im having guys haha i hooked up the safc up and works for little bit then the screen goes dead the buttons all lite up but not the screen is it because its not reading andy sensors because the motor isnt in!?that the screen goes out?

talk to magnamx5

here i am. Ok i pmed you lemme know if it is any help if it isnt ill get my head under the dash of mine and into the instruction book to help you with this.

Wow you guys have realy rusty fuel tank covers :gay:

Q: I just purchased and installed my unit. Unfortunately the VFD screen does not light up. The arrow keys do light up. What is the problem?
A: Although there can be many factors to this, there are three probable reasons for this situation. 1- During installation, the unit was either wired incorrectly or shorted. Electrical shorts can happen in an instant without any noticeable signs. Please be careful. Once the unit has been shorted, there is nothing that A'PEX can do to repair the unit. It must be replaced or purchased again. 2- Make sure that both grounds have been properly connected. 3- Although rare, the units are mass produced in large quantities and defects can happen. If the steps above do not correct the situation, kindly repack the unit with all original components and return the unit to the dealer of purchase accompanied with original receipt (Required to process requests). Warranty claims for electronics must be made within 30 days of purchase.
from safc website but i still think you have a ground issue.

guys it was the brown ground it must of got lose in the splice