96 Coil Pack Wiring
1 Attachment(s)
I converted my car a while ago to cops with megasquirt and now i need to go back to stock ecu and coils for california smog. My OBD fail and MS are not getting along :( . I lost the oem connectors for the stock coils but have some contacts that fit on the coils pins. I just need to know which pin is what now. Here is a pic and hopefully someone knows which pin goes to which wire.
Attachment 195077 |
I have it for you... Give me a few minutes.
|
1 Attachment(s)
this should be right...
|
Umm.. won't the stock ECU run your COP's? I was under the impression if you wired them for wasted spark like stock it would run just fine. Or is it an emissions requirement?
|
It will but the dwell settings are different. Technically you can run it. There is a chance of frying the coils though. Guys do run them without a dwell reducing circuit.
|
Originally Posted by 240_to_miata
(Post 618332)
It will but the dwell settings are different. Technically you can run it. There is a chance of frying the coils though. Guys do run them without a dwell reducing circuit.
|
No problem. Good luck. I gave up on trying to battle passing CT emissions with a parallel setup so I went back to stock ECU as well. I kept getting a CEL because the AFR's were too far away from what the stock ecu wanted to see.
I passed in about 10 minutes after using the proper driving cycle. You dont need to drive 100+ miles or w/e you just need to clear all the readyness codes. Search my old posts and you might find a thread or 2 about what info i followed to pass. |
All times are GMT -4. The time now is 04:16 AM. |
© 2024 MH Sub I, LLC dba Internet Brands