Coolant Line Question
Thread Starter
Elite Member
iTrader: (33)
Joined: Jan 2007
Posts: 2,522
Total Cats: 36
From: Newnan, GA
Coolant Line Question
Is using a -6AN line (3/8") too big for feeding coolant to the turbo? Currently running 5/16" hose, but changing everything to steel braided lines. However, the fitting I am going to use to connect the lines to the the hard pipes only come in -6AN and not -4AN.
Last edited by RotorNutFD3S; Jul 3, 2008 at 09:53 PM.
Reply
0
0
Joined: Sep 2005
Posts: 34,402
Total Cats: 7,523
From: Chicago. (The less-murder part.)
Are you asking if it's too big from a flow standpoint? No such thing when it comes to coolant lines.
Obviously it's not going to fit onto the existing water nipples on the block, but it sounds like you've got a plan to deal with that.
Obviously it's not going to fit onto the existing water nipples on the block, but it sounds like you've got a plan to deal with that.
Reply
0
0
Thread Starter
Elite Member
iTrader: (33)
Joined: Jan 2007
Posts: 2,522
Total Cats: 36
From: Newnan, GA
Ok, good to know! Just didn't know if too big a line makes it harder for the coolant to get to the turbo effectively.
Obviously. And yes, I do have a plan. I'll be posting up the finished result as soon as I get done with the project in case anyone else might be interested.
Obviously. And yes, I do have a plan. I'll be posting up the finished result as soon as I get done with the project in case anyone else might be interested.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
JesseTheNoob
DIY Turbo Discussion
15
Sep 30, 2015 02:44 PM
