Cracked tranny turret
 

As i was installing the engine today in my 90 project car. I was in the process of lining up the shifter turret and the opening in the cab. As i was doing this there was stress put on the turret and i saw fluid leaking :eek: . Grabbed a flashlight and saw this ( i pulled the engine out and snapped a pic )

SO basically i need to take off the turret and replace it with a new one from another transmission.

Is there a writeup on how to?

Do i have to take off the transmission tail?

Help please!

Can't help with that, but here's a tip.... Take the shifter off for installing the tranny

i learned the hard way

you should be able to remove it without taking the tail section off

i got the bolts off but i dont know how to get the shaft out... any ideas?

mate look at the diagram i posted see where it say New (9) you have to remove the pin in the shaft then the housing should slide off

Dr.

hey how do i remove (9) i tried for about 10 minuets and could not figure it out :noob:. I wanna get the motor in this saturday but i gotta get the tailshaft fixed help a nub out

trying to put the engine in with the shifter attached :ne: win

sorry mate, but that pin is a knock out type, get a puch or bar of the same size as the pin and knock it threw, i did a test run on a spare box and it turns out you need to pull the whole remote housing off, once you have undone the bolts and cracked the gasket you need to twist the housing clock wise to release the shaft. once that done you can remove the shaft and then the shifter housing should come away (remember the oil)

i hope this helps

Cheers
Dr.