flywheel alignment?
flywheel alignment?
New engine is going in later this week 
I noticed in the Haynes manual that you are supposed to mark the Flywheel so you can re-allign it. I'm putting a Fidanza flywheel on the new motor, is there any certain way it is supposed to line up?
I noticed in the Haynes manual that you are supposed to mark the Flywheel so you can re-allign it. I'm putting a Fidanza flywheel on the new motor, is there any certain way it is supposed to line up?
Reply
0
0
Make sure you get the correct bolts to match the threads in the flywheel when mounting the pressure plate. The ones from your OEM flywheel are a different thread and will destroy the threads in your Fidanza
Last edited by olderguy; May 6, 2008 at 04:45 PM.
Reply
0
0
Joined: Jun 2005
Posts: 19,338
Total Cats: 574
From: Fake Virginia
Reply
0
0
i did that....
i hit them ***** with an impact,
and was quite supprised when they stopped dead in their tracks about half way through,
had to re thread everything...
Last edited by olderguy; May 6, 2008 at 04:46 PM.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
graexodus
Miata parts for sale/trade
5
Oct 26, 2015 01:48 PM
