Input Shaft removal on manual tranny
I'm looking at attempting to remove the input shaft from my manual transmission.
I currently have the bellhousing off as shown. https://cimg4.ibsrv.net/gimg/www.mia...f396444623.jpgMX5 5 speed Am I correct in thinking that if I stick a punch down these holes that it will release the input shaft? https://cimg5.ibsrv.net/gimg/www.mia...82755e9543.jpg It's difficult to see the hole in the above pic (my iphone camera sucks) but there are 3 holes around this face. Do I punch out the roll pins inside? I haven't had any luck punching anything out yet but what I aiming for is this below. Any help? https://cimg6.ibsrv.net/gimg/www.mia...826c618f6a.pnginput shaft separated from gearbox |
All times are GMT -4. The time now is 08:49 PM. |
© 2024 MH Sub I, LLC dba Internet Brands