Input Shaft removal on manual tranny
08-28-2017, 03:13 AM
#1
Junior Member
Thread Starter
iTrader: (6)
Join Date: Aug 2008
Location: New Zealand
Posts: 248
Total Cats: 3
Input Shaft removal on manual tranny
I'm looking at attempting to remove the input shaft from my manual transmission.
I currently have the bellhousing off as shown.
MX5 5 speed
Am I correct in thinking that if I stick a punch down these holes that it will release the input shaft?
It's difficult to see the hole in the above pic (my iphone camera sucks) but there are 3 holes around this face. Do I punch out the roll pins inside?
I haven't had any luck punching anything out yet but what I aiming for is this below.
Any help?
input shaft separated from gearbox
I currently have the bellhousing off as shown.
Am I correct in thinking that if I stick a punch down these holes that it will release the input shaft?
It's difficult to see the hole in the above pic (my iphone camera sucks) but there are 3 holes around this face. Do I punch out the roll pins inside?
I haven't had any luck punching anything out yet but what I aiming for is this below.
Any help?
Reply
0
0
