6-spd problem
#1
Senior Member
Thread Starter
iTrader: (4)
Join Date: Nov 2009
Location: Toronto, ON
Posts: 1,446
Total Cats: 6
6-spd problem
Hey guys,
I just had my FM Level 1 clutch installed today. I have an issue now with shifting into reverse with the engine on. We adjusted the clutch pedal and there is negligible free play. It is very hard to put the car into reverse with the motor on. With the motor off, I can pretty much go through all the gears fine. The hydraulics are not leaking and have no air. Any ideas what my issue could be?
I came across this old thread where a reverse switch washer was missing. I don't remember having to remove the reverse switch....
https://www.miataturbo.net/showpost....1&postcount=21
I just had my FM Level 1 clutch installed today. I have an issue now with shifting into reverse with the engine on. We adjusted the clutch pedal and there is negligible free play. It is very hard to put the car into reverse with the motor on. With the motor off, I can pretty much go through all the gears fine. The hydraulics are not leaking and have no air. Any ideas what my issue could be?
I came across this old thread where a reverse switch washer was missing. I don't remember having to remove the reverse switch....
https://www.miataturbo.net/showpost....1&postcount=21
Last edited by dgmorr; 04-12-2010 at 03:02 PM.
#2
mkturbo.com
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,177
Total Cats: 1,681
Amazing job searching. I was about to post exactly what I said way back then. I know I had that problem on my 5 speed when I posted about that. When I switched out my 6 speed a few weeks ago I did not even take out the switch. I simply unplugged it. So I am not sure if the same issues even exists on the 6 speed. I would recommend going and checking, but if that is not it. I have no clue what it could be.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM