Too much timing? Need opinions.
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Nov 2007
Location: Saint Paul, MN
Posts: 1,489
Total Cats: 28
Too much timing? Need opinions.
Hey all, need someone to check out my timing map. I'm picking up knock above 4500 when I go WOT, from what I can tell when I go WOT in a higher RPM area (4.5k, 5.5k, 6.5k) and run to redline I pick up knock. I make very good power if there's no knock event (VERY good, actually). Go figure. The turbo is currently being stretched to it's limits, I imagine the 2560 is beyond maxed when it spikes to 18psi. I would very much like to switch from MBC to EBC, but alas it hasn't been fixed yet.
However, if I'm WOT from 3k-redline, there's no knock issue. I need an opinion on my timing map, if anyone has a chance to take a look. I'm hitting 11.3-11.5:1 for AFR during most cases. The only cases I am not keeping up is rapid switching between WOT and off. I have the knock sensor calibrated with a reasonable amount of breathing room, but it's possible I might have it too close. In any case, opinions?
Edit- Off the wastegate I see 14.5psi max and maintain 13-14psi without any knock events. And this is flooring it from 4, 5 and 6k to redline going from vac to 14psi.
However, if I'm WOT from 3k-redline, there's no knock issue. I need an opinion on my timing map, if anyone has a chance to take a look. I'm hitting 11.3-11.5:1 for AFR during most cases. The only cases I am not keeping up is rapid switching between WOT and off. I have the knock sensor calibrated with a reasonable amount of breathing room, but it's possible I might have it too close. In any case, opinions?
Edit- Off the wastegate I see 14.5psi max and maintain 13-14psi without any knock events. And this is flooring it from 4, 5 and 6k to redline going from vac to 14psi.
Last edited by Der_Idiot; 10-19-2012 at 01:23 AM.
#4
Former Vendor
iTrader: (31)
Join Date: Nov 2006
Location: Sunnyvale, CA
Posts: 15,442
Total Cats: 2,100
I'd bet $10 that you're getting tip-in knock due to boost overshoot. Flooring it from 3k doesn't allow the same overshoot, which means no knock.
My suggestion would be to switch to an ECU that has working EBC.
My suggestion would be to switch to an ECU that has working EBC.
#5
Senior Member
Thread Starter
iTrader: (2)
Join Date: Nov 2007
Location: Saint Paul, MN
Posts: 1,489
Total Cats: 28
^ That's possible. I'm not getting the issue with it if I go off WG pressure. I gotta look into how to re-enable it on 2.7 and test how it's working, but in the mean time here's my timing map in beautiful JPG format.
On a side note, they made an option to export maps to CSV and BMP, but the bmp spits out the map itself and not the timing table.
On a side note, they made an option to export maps to CSV and BMP, but the bmp spits out the map itself and not the timing table.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM