Maybe a stupid question but I gata ask.

A few of the guys I run with(wrx & srt-4) get flames out the exhaust.
How can I make my miata do this without hurtin anything?
I just want a little PUFF of fire when I down shift.

I'm already running rich; does it have something to do with exhaust diameter?
I know about using a spark plug but I don’t want to do that.

 

http://www.eatmyflames.com/

 

Save up for ***** enlargement surgery instead.:gay:

 

the rear window sprayer in the jeep is broken off so when you hit the washer it sprays straight back.

It's nice for tailgaiters but I want to figure out how I can put lighter fluid or gasoline in the reserve and some sort of lighter rig.

 

start running greater than 10:1 AFR. VTA your BOV. that shoudl do it. but most likely will dump a lot of black smoke as well.

 

Remove the cat.

 

Finally a reason to have 2 maps in your emanage

BTW, I have a really simple rig on my 70 olds with a 455. A momentary switch and relay remove the ignition coil and send signal to two coils (one clamped to each frame rail) under the car. Each of those coils has a wire running to a plug welded into the pipes. I'll give it a quick rev to 3.5k rpm, let off, then hit the switch. Usually good for ~6 ft of flame out of each pipe. Very cool at the cruise ins... I would not suggest anyone try it in the miata b/c you will probably foul your o2 and kill your cat. I'll look around, I have pics somewhere...

 

i know mine will backfire pretty loud sometime(bov and no cat) but i'm not sure if there's any flames

 

windsheild washer fluid is just isopropyl alcohol.

 

just take off the cat and downshift.

 

meth and water actually.

 

oh, I'm a jackass. Some friends shot it in a big VW emblem outside there shop, and burned that concrete clean once.