Integra Problem W/ Clutch Pushed In - Help Dx'ing the Prob
So I'm 300 miles away from home and I hear this weird sound from the 94 Integra (140k miles) whenever I push in the clutch to the floor, like a rubbing sound. Can't isolate the sound.
Rubbing/metallic sound when: -clutch pushed in (only 1st and 2nd gear makes sounds and only at low speed) and also makes sounds at a dead stop w/ clutch pushed in -hard to shift into gears (all gears) -car seems to stutter a bit @ <5 mph -runs fine when actually in gear Throw out bearing? Thanks. |
If it's the TOB
It will make sound when clutch pedal is pressed to the floor. Make sound when you put pressure on the clutch pedal but don't actually push the clutch in. (just pushing the TOB agains the PP) Sound disappears when clutch is disengaged. (TOB is away from the PP and no longer doing anything) |
Would the TOB also making shifting notchy and hard to get into gear?
|
I dunno. If it's not pushing the the PP all the way then yes it will make it hard to shift into gear. If you're hearing the sound like i described it's the TOB. Gonna have to pully the trans. to change it. Use a Timekon (sp?) or other known good brand. Ebay TOB's are known to fail. Also make sure the thing has grease in it. (rare but it happens!)
|
Not sure if this helps.. but on my 94 Integra with the same miles, the CMC went out. Perhaps its leaking? Check the floorboard of the car to see if there's any fluid.
|
Its the flux capacitor. Biff got into your car again.
|
Originally Posted by Fireindc
(Post 318587)
Not sure if this helps.. but on my 94 Integra with the same miles, the CMC went out. Perhaps its leaking? Check the floorboard of the car to see if there's any fluid.
|
i am a acura parts counterperson, let me know if you need any parts for it. i usually have the TOB in stock, and the CMC is only a day out. i can get you prices if you want some tomorow.
|
when my pilot bearing siezed I has a similar set of symptoms. just a thought.
|
+1 to bryantaylor, Honda factory parts are AWESOME!! Honda parts are a little pricey, but you get what you pay for. Are you still riding the original clutch? You might think about going ahead and changing it while the tranny is already off.
|
My CMC failure did not show similar symptoms. +1 on replacing the clutch when/if you pull the tranny.
|
whatever it is doesn't eraly matter because you have to take the clutch out. I had a clutch puke the springs out and tear shit up (exedy stock replacement).
|
i didn't know you had to pull a clutch to do a master, learn something new everyday
|
If it's making bad metallic grinding noises, it's not the master or slave. If it were either of those it just wouldn't go in gear.
|
Originally Posted by patsmx5
(Post 318835)
If it's making bad metallic grinding noises, it's not the master or slave. If it were either of those it just wouldn't go in gear.
|
All times are GMT -4. The time now is 08:26 AM. |
© 2024 MH Sub I, LLC dba Internet Brands