afr target tables?
just working my tune a little bit tonite and tomorrow after i swap in my 550's, and figured i'd see what everyone else is using for an afr target table in MLV.
http://i117.photobucket.com/albums/o...n_mac/afr1.jpg thoughts? comments? discussion? |
I would richen it up more above 5800. Try shooting for 12.5:1 as you approach redline.
|
hmm... think so, even in vac? in boost i agree, but i think the only time i'm gonna see those high rpm vac cells is if i'm cruising at a lower gear or high speed...
|
Are you running MS I or II? I thought I read something about 12x12 AFR in msI high res, but I am unable to find anything on it. Just wondering since you have a 12x12 table
|
running MSI, but this is the afr target table from megalogviewer. i possibly should have specified that.
|
yo shit is lean at 100kpa, nga. Go 12.5 at 4000rpm+ through there.
|
Is there any way to edit the Default AFR table in MLV and save it?
It seems like a lot of work to edit the table before every analysis just to get your desired AFRs. It allows you to export the edited table as a vex but not to import it. Just new to this stuff. Thanks |
hmm, i have started and shut down MLV a boatload of times now, and my afr target table just stays the way i leave it, everytime. did you pay the 20 bucks for the software? maybe if you haven't pair it doesn't remember anything?
|
Originally Posted by bjsinfield
(Post 253721)
Is there any way to edit the Default AFR table in MLV and save it?
It seems like a lot of work to edit the table before every analysis just to get your desired AFRs. It allows you to export the edited table as a vex but not to import it. Just new to this stuff. Thanks NO idea what you are talking about here. I have never had an issue with MLV saving my AFR table. As the previous poster said it loads automatically each time I open it. And that was the case before I paid for the software too. Are you accidently looking at the narrowband AFR table in MLV? |
1 Attachment(s)
here is the afr table i run
|
Originally Posted by paul
(Post 253770)
Are you accidently looking at the narrowband AFR table in MLV?
yeah, this is a good point, as well. it took me a few minutes to poke around enough to get the 12x12 afr target table i posted to be the active one. you sure you're looking at the right table when you load it up? |
|
hehe, any idea where i got my starting target table from? ;-)
|
DOH!
If you edit the table and exit using the close windoe option rather than the 'EXIT' button it does not save the table. Thanks, your comments got my brain started. |
All times are GMT -4. The time now is 07:31 PM. |
© 2024 MH Sub I, LLC dba Internet Brands