Alternator Control in Rev MS3
My MS3 Enhanced from Rev is tuning nicely now that I incorporated the AFR table into VE Analyze Live. It starts, runs and pulls nicely.
I'd like to use the alternator control in the MS3 to disable the alternator output until 5 seconds after the car starts. In my tune, alternator control is currently disabled. It looks like turning the alternator control to "on-off", then change the idle up time from 3 seconds to 5 seconds should be all I need. Is this the right way to go about doing this? |
there's literally a parameter in the code called "Start Delay(s)"
Is Reverant even using the built in alternator code? I thought he handled the alternator with his own circuitry. |
Sorry, that's what I meant, not "idle up".
I'm just wondering if there is anything else that needs to be considered before turning this on. |
if reverant even uses it. that's to be considered.
|
The Enhanced MS3 has its own alternator control, including electrical load idle-up. No, there's no option for an afterstart delay for the alternator control. Do you have any issues with it?
|
No, no issues at all. Was just getting a bit slower of an initial firing on cranking than on stock, so I was troubleshooting to see if the alternator load was causing it.
|
All times are GMT -4. The time now is 08:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands