Instructions for using AEM widebands with MSLabs CAN Wideband Module

1. Install your CAN Wideband Module according to the instructions from our website. Complete steps 1 through 4, then stop and complete these instructions.
2. Download the CAN Wideband Module INI file from our website: http://www.trackspeedengineering.com...nd-Module.html
3. Open your TunerStudio project. Click File>Project>Project Properties. Click the "CAN Devices" tab.
4. Next to CAN Devices, click the plus sign to add a device. Next to "Device Configuration File", click the "..." button. Navigate to the CAN Wideband Module INI file, click "open", then click "OK."
5. Your project will close and re-open automatically. In the upper left-hand corner, you will see a new Device drop- down menu. Select "CAN1" (or the custom name you used for your CAN module), then click "CAN Wideband Module Setup" at the top of the screen. Click "CAN Wideband Settings" from the dropdown menu.
6. Next to "Wideband Model" select "AEM" , then click "Burn", then "Close".
7. Click Tools>Calibrate AFR Table. Next to "EGO Sensor", select "Innovate LC-1/LC-2 Default" (not a typo - you must select Innovate even when using an AEM wideband). Click "Write to Controller", then "Close".
8. Complete steps 5 through 18 of the normal instructions.


Did you follow the instructions in step 7?

I use the AEM X UEGO and I want to connect it to the ms3pro via can as in the attached photo, I have the same WB.
I connect it directly to the CAN of the MS3PRO but in the software configuration it seems that something is wrong.
Question, is it very necessary to use the "MSLabs CAN Wideband Module"?
or the AEM X UEGO can't be connected directly?
https://cimg9.ibsrv.net/gimg/www.mia...2f251d940a.png

No, if you do some searching you can find some posts on how to set up your MS CAN to work on AEM Net but you will loose the ability to connect any other CAN devices to your network.