Completed DIYMS2
 

Hello! I believe I have just finished building my DIYMS2 for my 1993 Turbo Miata, which currently running off an old MSD ignition boost control box. Is there anyway someone could take a look at my completed board to see if I did everything correctly and will not blow anything up immediately?
I followed Braineack's guide to building it, from several different sources. I am running it as a standalone, and I also installed the boost control module so that I can use EBC at some point.
Thanks!
https://cimg6.ibsrv.net/gimg/www.mia...a08a6663f9.jpg
I threaded the boost control wires through the original Q12 heat sink lead holes
https://cimg6.ibsrv.net/gimg/www.mia...cc0c998e02.jpg
https://cimg2.ibsrv.net/gimg/www.mia...e9cb8cdde0.jpg
The yellow is much more obnoxious than I thought....
https://cimg4.ibsrv.net/gimg/www.mia...68869f4024.jpg
Quite a mess back here