Completed DIYMS2
#1
Completed DIYMS2
Hello! I believe I have just finished building my DIYMS2 for my 1993 Turbo Miata, which currently running off an old MSD ignition boost control box. Is there anyway someone could take a look at my completed board to see if I did everything correctly and will not blow anything up immediately?
I followed Braineack's guide to building it, from several different sources. I am running it as a standalone, and I also installed the boost control module so that I can use EBC at some point.
Thanks!
I threaded the boost control wires through the original Q12 heat sink lead holes
The yellow is much more obnoxious than I thought....
Quite a mess back here
I followed Braineack's guide to building it, from several different sources. I am running it as a standalone, and I also installed the boost control module so that I can use EBC at some point.
Thanks!
I threaded the boost control wires through the original Q12 heat sink lead holes
The yellow is much more obnoxious than I thought....
Quite a mess back here
Thread
Thread Starter
Forum
Replies
Last Post
y8s
DIY Turbo Discussion
47
09-12-2012 05:33 PM
StankCheeze
Miata parts for sale/trade
0
08-19-2012 02:58 PM
kotomile
Insert BS here
6
09-28-2008 09:12 AM