Hello,
I'm setting up the map sensor calibration.
I'm using a zeitronix 3.5bar map sensor with output 0.5v:0 psi /4.5v: 50psi absolute pressure.
How can I input this values in ms-2 ? The ms-2 bandwith is 0-5v

 

Figures that you have an MS2... I spent all this time tracking down information on how to reconfigure and recompile the code, but that was for MS1.

I honestly don't know how the system will react to a negative number, but try this:

 

Thank you Joe, the numbers I've entered before reading your post were very similar to yours. I' ll try yours too and I'll come back for feedback.

 

Joe you are great man! I am reading 100 kpa with your numbers.
I know I am off topic but I cant get my car to start.
I'm seeing rpm in tunerstudio , but I get no spark or fuel. :(