D14 and D16 always on
I noticed that when I power up the MS2 D14 and D16 are always on, I am running the improved spark output mod.
I have yet to test everything with jimstim and tunerstudio, but just wondering should these be on all the time? This even happens when I pull the MS2 expansion card. I looked for a short in the U1 as well as the led drive transistors. Everythign checks out fine... |
Be sure spark output is set to going high / inverted.
|
the LEDs will appear to "look" always on. Test them back to 5v and you can see them clicking on and off rapidly.
|
1 Attachment(s)
https://www.miataturbo.net/attachmen...ine=1327462550
Please confirm my understanding of the above diagram. Using D14 led drive as an example. Cpu output not active, 0V @ Q6 base, Q6 switch off 5V @ 2N3904 base, 2N3904 switch on, D14 to ground (led glowing red) 0V potential @ 2N3904 collector, igniter coil not active. So basically cpu signal off -> led "on" -> Coil inactive Therefore even if the cpu is removed form the board and power is applied the led will still be active. Is this correct? |
All times are GMT -4. The time now is 12:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands