DIY MS2e Gone Sequential Injection but Won't Start
8 Attachment(s)
DIY MS2e was running great on batch fire, so I had to go and mess with it by putting the JB Perf Quad Ignition & Injection board in.
I followed all the instructions for the Quad Board. Using testmode, outputs were working through the DIY BOB with the Jim Stim. I put it on the car, and it doesn't even try to catch. Everything I'm looking at looks OK to me in the logs I just have no clue what to look for now. Stock ECU is getting me around just fine now while I grapple with this. Swapping MS2 in and out is only a couple minutes job. https://www.miataturbo.net/attachmen...ine=1466041675 Attached is the tune, datalog, and composite log. Please let me know if I can provide anything else that may help you help me. ~Chris |
You've got a good RPM signal - check your timing with a timing light next and see if it's correct. If it is, adjust the fueling.
|
All times are GMT -4. The time now is 02:03 PM. |
© 2024 MH Sub I, LLC dba Internet Brands