Diypnp 93 miata start but stalls instantly
I have a 93 miata stock besides intake and lc-1 wideband sensor
I got my diypnp assembled up and hooked it up to tuner studio started the car and it started up then stalls immediately i tried again and I've i give it gas it'll stay alive but runs pretty rough. I'm wondering why its doing this. In the instructions it says INJ1 4Y, 4Z and INJ2 4U, 4V does this mean wire from the INJ1 to both 4Y and 4Z same with INJ2, or means i can use either one of them? Also is it needed to remove resistor R14? is it just optional if I'm wanting to run ac? |
ASE.
In the instructions it says INJ1 4Y, 4Z and INJ2 4U, 4V does this mean wire from the INJ1 to both 4Y and 4Z same with INJ2 Also is it needed to remove resistor R14? is it just optional if I'm wanting to run ac? |
got it running now I'm on to tuning any suggestions brain? Im working on the ve fuel tables to just get it to idle smooth and all when i push on the gas it lags about a second behind thats the map dot or tpsdot correct that i need to adjust to fix that?
|
have you installed a vTPS? if not, then it's all in MAPdot AE tuning.
|
i saw somewhere saying to not mess with accell enrichment until i have my ve fuel table dialed in is this true?
|
All times are GMT -4. The time now is 09:57 PM. |
© 2024 MH Sub I, LLC dba Internet Brands