DIYPNP jumper questions
Finishing up my DIYPNP, im using the jumper configuration from here: (DIYPNP MegaSquirt installation for the Mazda Miata), now i understand the edge pin connections but there are a few things confusing me.
-for edge pin 1U* (fuel pump) what does the apostrophe represent? -are ign1 & ign2 the same thing as ig1 & ig2? -what do I do for the ac circuit in the I/o section if i have fully removed ac and ps? Do I keep r14? Remove it? I apologize if these have been answered elsewhere, the various versions/types of megasquirt make it very confusing for me when searching for correct information. |
anyone?
|
Originally Posted by Campbellsouup
(Post 1121059)
-for edge pin 1U* (fuel pump) what does the apostrophe represent?
*European '96-'97 models with immobilizer use 1V for the fuel pump output. -are ign1 & ign2 the same thing as ig1 & ig2? Yes. -what do I do for the ac circuit in the I/o section if i have fully removed ac and ps? Do I keep r14? Remove it? If it's in, leave it. If you didn't put it in, leave it out. It won't matter. |
what model year. id wire the a/c up so you can use the gslender firmware.
|
I assumed he has a 96-97. It's the only one that mentions the 1u* on the documentation.
|
Yes it's a 96, thanks diesel. Also any connections i need to make other than the ones directed in the vehicle specific instructions?
|
All times are GMT -4. The time now is 05:09 PM. |
© 2024 MH Sub I, LLC dba Internet Brands