DIYPNP, Launch control - how to ?
Hey,
I use a DIYPNP and I would like to activate the launch control option. What do I need to do ? Thanks ! |
Assuming your unit has it wired in?
Mine didn't originally. |
Well.. no,
What do I need to do in order to be able to use launch control ? |
what model year?
|
97
|
Minimum you need a switch wiring in to activate it. Mine uses the clutch switch.
I also use VSS to disable it above 10mph, so during hard driving it doesn't accidentally become engaged during a gearchange. |
for launch i'd do 1L into input 2 IN, then input 2 OUT to FLEX.
that's it. for you idle question in PM, all you need to makre sure is that you have 4Q to IAC. and you shoudl have installed a diode on the IAC jumper by where you added the VR and OP- pull ups on the bottom right side of the board. thats it. |
Ok, thanks, I'll make the launch control ready asap.
About the closed-loop PID IAC tune, it is working just needs a little tune. It is a 1997 miata |
Originally Posted by Braineack
(Post 985404)
for launch i'd do 1L into input 2 IN, then input 2 OUT to FLEX.
that's it. |
All times are GMT -4. The time now is 02:05 PM. |
© 2024 MH Sub I, LLC dba Internet Brands