Double check my ms3x build
2 Attachment(s)
I bought a MS3x from DIYautotune last year, assembled it and then I ran out of time and did not touch it until now.
I think that I used the DIYautotune instructions to assemble and I think that everything is there but I would appreciate if someone could have a look to be sure that I did not forget anything. I intend to install it in my currently stock 2003 miata. thanks! https://www.miataturbo.net/attachmen...ine=1459177331 https://www.miataturbo.net/attachmen...ine=1459177331 |
looks good to go to me.
|
Thanks Braineack!
I have one more question for you. In one of your post (that I am unable to find right now), I remember reading that a pullup resistance is needed to control the NB alternator. Is this the case? What is the best way to do that? |
Should I just pick any unused PWM output and connect a 1k resistor between the DB37 pin of the output and the 5v on the proto section of the board?
|
1 Attachment(s)
i use the VVT output and do a 1K resistor to VCC.
https://www.miataturbo.net/attachmen...ine=1459363798 |
Thanks!
|
All times are GMT -4. The time now is 05:09 AM. |
© 2024 MH Sub I, LLC dba Internet Brands