driving two coils on ms1 v2.2
Has anyone done mods needed to drive two stock miata coils on the ms1 v2.2 board? I appericate the information
THanks |
is it possibile to just drive the igintor instead to fire the coil packs?
Thanks Gonna search around the ms extra manual |
you do it like any other v3.0 install....um i have the diagram somewhere... let me look for it.
|
I appericate the help
|
http://www.boostedmiata.com/gallery2...-1/v2board.JPG
use 100ohm instead of 300ohm. That's going back to pin 11 through that 1K resistor. Normal = non-inverted |
huh is the red setup for the cas pickup? the one with a 1k resistor on it, the part where it goes between d9 and r13 where is the trace from or going to, if you don't mind that is, my board doesn't seem to have a hole there like that. But there is a hole in the board further to the db37 but in the same middle area.
Damn I need better info but I appericate it atleast its a working area to go from. |
red is tach input, blue is spark out.
post pics, they might have modded the board? http://www.bgsoflex.com/v22/msv22.html http://msextra.com/doc/ms2extra/MS2-Extra_4g63.htm |
sorry forgot to mention its a v1.01 board, I"m mainly using the v2.2 as a reference because there is more info on it. uploading pics now
|
http://img38.imageshack.us/img38/388...2721h57m28.png
By techsalvager at 2010-07-27 http://img838.imageshack.us/img838/7...2721h57m50.png By techsalvager at 2010-07-27 Apologies of the bad blurriness of them. Anyways I used pin two off the cpu to connect the .1uf cap to. but I'm not sure my 5v pull up for the cmp signal is correct. |
beyond me...
|
haha well if you have some pictures of the mods on a real board I would appericate it to see it. I could go from there.
|
i do not iirc. id have to look on my desktop pc.
schematics in link should help |
yeah I see now better where the two wires for the igintor is going.
|
ok I did the coil mod I just had to wired it from the LEDS to the db37 directly since I don't have a pin hole that connects at those sports, should still work fine.
|
Wow...
I haven't seen a rev 1 board in... ever. That is all. I have nothing useful to contribute. |
Originally Posted by Joe Perez
(Post 608182)
Wow...
I haven't seen a rev 1 board in... ever. That is all. I have nothing useful to contribute. |
Originally Posted by Braineack
(Post 608015)
you do it like any other v3.0 install....um i have the diagram somewhere... let me look for it.
|
ignitor.
|
V1.01s are pretty much V2.2s without the breakout jumpers to make adding extra circuits easier.
|
All times are GMT -4. The time now is 12:30 PM. |
© 2024 MH Sub I, LLC dba Internet Brands