EBC and the DIYPNP
 

Hey gang, I have a possibly stupid question... But that's ok.
I have a DIYPNP MS2 for my 99. I decided it was time to upgrade to Electronic Boost Control and have it controlled by the ECU. So I got the EBC Solenoid and addon kit from DIYAutoTune.
It came in today so I pulled my ECU to get started. In searching for install instructions that I could understand, I pulled my ECU apart to check what I had to work with, as it has been a while since I built this.
It LOOKS like the DIYPNP has the EBC circuit already built in and populated. Is that correct? There is a Boost Control section on the board and it has an IRLZ44 in it already it seems... So if that is the case...
I can just worry about figuring out what pin to wire the EBC to right?

Thanks,
Randy

See, I knew it was a stupid question :D I answered it myself by going back over my documentation from when I put the ECU together... Yes, it is built in.

Hello, first post ever! Good to hear you figured it out. I am building my own diypnp for a 99. Ive built the main board per diyautotunes instructions, but i am concerned with the next stage...jumpering everything. Got any advice besides the instructions on the diy website?

Welcome to the madness.

This guy did a really good walkthru of the assembly.
Engine Management Megasquirt DIYPNP "How-To" - Step-By-Step Instructions - Miata Forumz - Mazda Miata Chat Forums
Other than that, just go over the pinout for the 99 very carefully... and take your time.

That guy is awesome.

Yes he is :D Funny thing that..... He lives in the same town as you! ;)