Hey gang, I have a possibly stupid question... But that's ok.
I have a DIYPNP MS2 for my 99. I decided it was time to upgrade to Electronic Boost Control and have it controlled by the ECU. So I got the EBC Solenoid and addon kit from DIYAutoTune.
It came in today so I pulled my ECU to get started. In searching for install instructions that I could understand, I pulled my ECU apart to check what I had to work with, as it has been a while since I built this.
It LOOKS like the DIYPNP has the EBC circuit already built in and populated. Is that correct? There is a Boost Control section on the board and it has an IRLZ44 in it already it seems... So if that is the case...
I can just worry about figuring out what pin to wire the EBC to right?

Thanks,
Randy

 

See, I knew it was a stupid question I answered it myself by going back over my documentation from when I put the ECU together... Yes, it is built in.

 

Hello, first post ever! Good to hear you figured it out. I am building my own diypnp for a 99. Ive built the main board per diyautotunes instructions, but i am concerned with the next stage...jumpering everything. Got any advice besides the instructions on the diy website?

 

Welcome to the madness.

This guy did a really good walkthru of the assembly.
Engine Management Megasquirt DIYPNP "How-To" - Step-By-Step Instructions - Miata Forumz - Mazda Miata Chat Forums
Other than that, just go over the pinout for the 99 very carefully... and take your time.

 

That guy is awesome.

 

Yes he is Funny thing that..... He lives in the same town as you!