EBC and Idle
 

I've never been able to get my idle to work right and at some point my boost control just stopped working. I just got a new MS chip thinking it may have been the problem. I replaced it and still no good. I did realize something on the boost, though. It works when the car is off, but the second I turn it on, it stops. I set everything to 100 duty cycle to check it and the light turns on when the car is off, but it turns off when the car is on. I set it to 50 to see if it would click and it did while the car was off.

Has anyone had luck with EBC or idle with HR_10g? I'm thinking of going back to the standard MSnSE to see if it works.

OK, I've narrowed it down a little more:

I installed an easythermed version of 029y4 and loaded my MSQ. Boost was working until I turned the car on, then it no longer worked, even if I loaded my MSQ again and turned the car off/on. I reloaded the firmware and loaded the MSQ and it worked again until I started the car again. It looks like there's a memory leak somewhere. I even installed the megatune version supplied with 029y4 to make sure it wasn't anything in my megatune configuration. I guess I should burn the firmware without easytherm and see if it does what it's supposed to minus the screwed up temp sensors.