f**up my cars diypnp
Ok so the car is running after the engine swap.
Doing good so I mess with the idle controls thinking I wired them backwards. Have the wire stripped and switch them and wrap with a little elect tape. Nothing much happens so I grab the wires to make sure connected and one touchs the engine bam! engine stops. Will not start. I check fuses 30 amp in box under hood blow. I replace still will not start and tuner studio can not read diypnp. Cant reflash firmware times out error 0xe0 VVT light is on so I guess there is power. Any ideas or am I just screwed |
well it started for a second with stock ecu. So power to diypnp should be good aswell as ignitor and coils. Any idea?
|
Open it up, see if it is burnt.
|
well it would not load firmware no matter how many times I tried but once I opened it up and loaded the firmware with boot jumper in it worked.
So I had to reset all the calibaration stuff and other setting but She runs again. |
All times are GMT -4. The time now is 06:53 AM. |
© 2024 MH Sub I, LLC dba Internet Brands