Ok so the car is running after the engine swap.
Doing good so I mess with the idle controls thinking I wired them backwards.
Have the wire stripped and switch them and wrap with a little elect tape. Nothing much happens so I grab the wires to make sure connected and one touchs the engine bam! engine stops.
Will not start.
I check fuses 30 amp in box under hood blow. I replace still will not start and tuner studio can not read diypnp. Cant reflash firmware times out error 0xe0
VVT light is on so I guess there is power. Any ideas or am I just screwed

 

well it started for a second with stock ecu. So power to diypnp should be good aswell as ignitor and coils. Any idea?

 

Open it up, see if it is burnt.

 

well it would not load firmware no matter how many times I tried but once I opened it up and loaded the firmware with boot jumper in it worked.
So I had to reset all the calibaration stuff and other setting but She runs again.