Fuel inject run out of control
I have tried all I can but the problem still.
The car go super rich and thick white smoke coming out from the back. wideband meter point from 14 and move slowly to 10 . Tried once , the wideband meter suddenly pointed to 19+ and not responding anymore and the white smoke gone and run fine. Have checked cylinder compression shows balance on all 4 cylinder. Have changed the MS tune, have changed the spark plug, injector, COP, wideband sensor, and also changed to my old MS2 from my MS3X. The problem still. Any Idea? Thanks |
Post a tune and datalog of the problem.
|
2 Attachment(s)
after done a few check, I found the problem is from the MS3X.
The problem now is cylinder 1 has a higher voltage (4.xx V) than the other 3 (1.xx V) at idle. Flooding the cylinder1. The smoke from MS2 was the remaining fuel from flooded cylinder1. The resistance on the lowest chip in the pic (in the blue ugly circle I drawn) was around 10 time lower than the other 3. So is it the hardware failure ? |
Or can I use injector 5-8 and leave 1-4 alone?
|
All times are GMT -4. The time now is 08:42 PM. |
© 2024 MH Sub I, LLC dba Internet Brands