Just picked up a "new" MS1 V3, what needs changing?
Hi, I have just managed to get hold of a cheap MS1 V3 nd need to know what needs changing/modding and if anyone knows how it is currently setup.
[IMG] Uploaded with ImageShack.us[/IMG] Sorry about the fuzzy pic, I have not seen a MS board with this much stuff on it and I assume much of it needs to go. Sorry again for the nooby post but I would really appreciate some help, thanks guys :) |
My suggestion to you would be to take a look at Brain's diagrams in the Megasquirt section of the forum here.
There is a "what you need to install" diagram. Also read up on the miata input and spark mods. They will need to be installed on the board before it will run your car. If it helps, get a copy of the megamanual and read through it to check that everything was installed properly. |
that image killed my bandwidth.
just needs miata specific mods. |
Also, it looks like that was set up to be triggered by a VR sensor directly judging from the jumpers and the inclusion of the trimpots.
Where did you buy it? Another car forum? Ebay? |
From eBay, I'm assuming this is going to be difficult to reverse? Not too much of a problem as I got it for £100. Is the fact it has been built to trigger off vr only going to be a problem?
|
Originally Posted by Pickle
(Post 643825)
From eBay, I'm assuming this is going to be difficult to reverse? Not too much of a problem as I got it for £100. Is the fact it has been built to trigger off vr only going to be a problem?
No and No. Easily fixed by someone who can solder. VR components are optional and are ignored when properly set up. |
Good times, Would anyone be able to share some useful links? I appologise if they are obvious but it's 11.30pm here and I'm shattered/7 stella's down... thanks for your help so far though :)
|
Look at my first response to this thread, there are a few links in it.
|
Originally Posted by Jeff_Ciesielski
(Post 643829)
VR components are optional and are ignored when properly set up.
|
Morning, right, one last noob question before I break out the soldering iron...
Can all the existing components be left in place when I do the mx5 based mods? (I'm assuming probably not, but hoping yes lol) |
All times are GMT -4. The time now is 09:31 PM. |
© 2024 MH Sub I, LLC dba Internet Brands