MS-PNP tach out?
I see in Tuner Studio the ability to enable a tach out signal from the mega-squirt. Did the pre-assembled MS-PNP have the hardward to generate that signal? Does the output signal need any external circuit to drive the dash tach
|
you should already have it on your 94-95 MSPNP. goes to 4O IIRC. dont hold me to that.
|
Thanks Brain; now to verify that the shop that tried to install the MS2 and failed, resulting in the re-install of the MS-PNP did not cannibalize that circuit for their failed attempt to add a GM tach generator
I am assuming pin 40 is on one of the two connectors on the MS-PNP is there an online resource with the various pin-outs |
my goals
1 - get tach working again 2 - get preliminary spark table created/loaded 3 - get idle, cold start, accel/decal adjusted stable 4 - get AFR targets created/loaded 5 - adjust *.ini code to cause AEM WB and TS to agree at 14.7 6 - get VE table created/loaded 7 - tune, retune, retune 8 - modify MS-PNP to eliminate backfire at switch on 9 - start all over with MS2 |
All times are GMT -4. The time now is 07:20 PM. |
© 2024 MH Sub I, LLC dba Internet Brands