MS Problem - Car wonīt pass 3k rpm
Iīve a MS from Brain.
The firmware is the hr10g and have a 4 bar MAP. The car is a NA6 from 1993(EU car) with a BP4w engine without MAF. VICS is disconnected. The Problem is that the car wonīt pass 3000rpm, it has lots of hesitation and cannot pass that. Between 1000 and 3000rpm runs... but itīs not very smooth. The following maps is what came in the MS. http://jdmtech.planetaclix.pt/mx5/spark.jpg http://jdmtech.planetaclix.pt/mx5/VE1.jpg how can i set the DIY basemap and set the right range for me? Iīve try to put the DIY basemap in the MSPNP website but I got the following errors. http://jdmtech.planetaclix.pt/mx5/error1.jpg http://jdmtech.planetaclix.pt/mx5/error2.jpg I still tried to upload that map but without sucess, seems that the MS wonīt accept it. can you help me scale and put a right spark and VE table for my NA car I donīt have turbo. Can someone help on this matter? supply me a basemap to my car? thanks |
please help, anyone?
|
have a data log also do you have a wideband?
|
i have no data yet. i have a LC1.
i will finish the install of the LC1 that i have without a gauge... and i will do a log soon, hope you can help me. |
Turn off launch control.
|
2 Attachment(s)
http://jdmtech.planetaclix.pt/mx5/log.jpg
i did a short log today... after i upload this new msq from mspnp website the 96-97 it does the same thing... at 2500rpm has lots of hesitation and the spark goes from 26 to 6 degrees... and keeps doing this... i will install my lc1 soon so i can gather more information. if you can point me in the right direction i appreciate. thanks Pedro |
Originally Posted by chicksdigmiatas
(Post 619166)
Turn off launch control.
|
Originally Posted by Baal
(Post 617762)
|
looks like he has a timing table for a 2-bar sensor but selected 4-bar so it screw up the scaling...
|
Agreed, but the end result of using that table as-is probably involves a loud metallic bang...
|
i agree, but the table is good if re-scaled correctly
|
So what should i do to get the car going as normal? can you help me please?
|
All times are GMT -4. The time now is 09:39 PM. |
© 2024 MH Sub I, LLC dba Internet Brands