I´ve a MS from Brain.
The firmware is the hr10g and have a 4 bar MAP.
The car is a NA6 from 1993(EU car) with a BP4w engine without MAF.
VICS is disconnected.


The Problem is that the car won´t pass 3000rpm, it has lots of hesitation and cannot pass that. Between 1000 and 3000rpm runs... but it´s not very smooth.


The following maps is what came in the MS.




how can i set the DIY basemap and set the right range for me?
I´ve try to put the DIY basemap in the MSPNP website but I got the following errors.



I still tried to upload that map but without sucess, seems that the MS won´t accept it.

can you help me scale and put a right spark and VE table for my NA car… I don´t have turbo.

Can someone help on this matter? supply me a basemap to my car?
thanks

 

please help, anyone?

 

have a data log also do you have a wideband?

 

i have no data yet. i have a LC1.
i will finish the install of the LC1 that i have without a gauge...
and i will do a log soon, hope you can help me.

 

Turn off launch control.

 

i did a short log today... after i upload this new msq from mspnp website the 96-97

it does the same thing... at 2500rpm has lots of hesitation and the spark goes from 26 to 6 degrees... and keeps doing this...

i will install my lc1 soon so i can gather more information.
if you can point me in the right direction i appreciate.

thanks
Pedro

 

What he said.

 

I hope that you won't be going into boost on that ignition advance table--the MAP scale isn't very motor friendly. Take a look at our MSPNP advance tables for a better start...

 

looks like he has a timing table for a 2-bar sensor but selected 4-bar so it screw up the scaling...

 

Agreed, but the end result of using that table as-is probably involves a loud metallic bang...

 

i agree, but the table is good if re-scaled correctly

 

So what should i do to get the car going as normal? can you help me please?