MS question about load points
 

Is there an easier way of changing the load points on your VE map?

On my VE map, it has areas of 180-240 KPA, that I don't use.

Is there a way I can rescale the entire map so I can finer cells?

So I'd like to have 180 KPA as my max, rather than 240 KPA, so I can have more load cells.

Also, is there a way to do that with RPM's? If not, I'll do it the long way, but was wondering if there was an easier way of doing it in TS.

do it.

no real easy approach. just spend some time and make it happen.

Okie dokie. That's all I needed to hear. Thanks.

yes and yes

click on the value, input new value, press enter

update map accordingly

done

See red circle in the picture below. Click that and you will be able to put in your new Bin values and the table will interpolate your existing table values to the new parameters.

I suggest saving your tune first, but will say it works well at least for going smaller, as you are suggesting. Interpolation seems to work better than extrapolation.

https://www.miataturbo.net/attachmen...1&d=1427997193

Thanks! I was able to rescale the load and rpm's rather easily.

I got VEAL to work perfectly now!