MS shift light
2 Attachment(s)
Hey,
I run DIYPNP and I want to add a shift light and then some other lights :) Tell me if I make sense. I run DIYPNP with A/C idle up using output WLED. If I understand correctly I have ALED,PT6 and PT7 outputs available. I can use them for shift light, I just need to add a resistor, PT6 and PT7 are direct cpu pins, so I just put a resistor on the proto area and make connection to PT6 and my LED ? (of course after defining the condition for this output) https://www.miataturbo.net/attachmen...1&d=1427736860 Then I can make lights for any other MS parameter the same way... (at least two more - outputs limited) Make sense ? Thanks ! |
I understand now that my sequential interjection occupy PT6 and PT7...
Can I use relays, nitrous or boost control to activate shift light ? |
I can't directly answer your question. However, there was this thread that I plan to mimic.
https://www.miataturbo.net/general-m...t-light-79996/ |
I'm currently using nitrous 1 to trigger my check engine light to use as a shift light. So yeah nitrous 1 should work.
|
Looks like you've got ALED free to use as a shift light. It can ground the shift light directly.
|
All times are GMT -4. The time now is 08:09 AM. |
© 2024 MH Sub I, LLC dba Internet Brands