MS2 wont flash
So i got my new MS2 built and i used my old MS2 daughter board. I went over the whole build before i even powered it up. Everything looked good, so i powered it up and everything seamed good. The lights flash once when i turn the key on. So i take it everything is good, so i try and flash the ms2 but no matter witch way i try to flash it i cant get the MS2 to communicate.
Any one know why my ms2 is not communicating? |
(zack morris's phone)
Boot jumper in? |
yes boot jumper in.
The three led only flash when i turn the key from off to run. They only flash once very quickly. |
Could my daughter board be bad?
|
You need to do the serial loopback test that are called out in the build manual to try to rule in/out what could be wrong, but with the way I understand that you had grounded your MS2 through the EDIS module, I wouldn't be surprised if the processor is fried.
http://www.msextra.com/doc/ms2extra/serial_setup.html |
I tried that test before i posted so im guessing my daughter board is no good.
|
1 Attachment(s)
Here is a screen shot of what i get every time i try to flash MS2.
|
Okay i got a new daughter board and check everything over and over more time then you could shack a stick at, and still no flash. WTF What could be wrong matt went over my wiring and i fixed a few small things, the ecu looks fine no burning or any of that but still cant get it to flash. I tried 2 laptops and 1 desktop still nothing.
|
lars would get that same reaction on a mac. used my pc and it flashed instantly.
|
Braineack, Anyway i could send you my MS2 and have you flash it for me so this way i know it works???
|
(zack morris's phone)
What data cable are you using what os? |
prolific usb to serial with a serial from diy and XP.
|
Okay anyone know what could be wrong??? I went over the board with a multimeter and everything reads good power, grounds, resistors, diodes, and capacitors. Could i have a faulty bored? I have tried other laptops and desktops just using the serial cable.
Matt anyway i could mail you my MS2 and have you guys look at it? Its the last part i need for my car i have everything done besides this MS. |
Okay if i power up the MS2 and i check for power i have no power at the daughter board on the square pin.
|
That's pin 1 (Vsyn). Should be easy to trace back:
http://www.megamanual.com/ms2/v3pcb_6.gif Damn image won't show: http://www.megamanual.com/ms2/v3pcb_6.gif |
The link you have posted wont doesn't load.
|
Now the image works.
|
Just went over the board again and found i dont get any readings from r23 no voltage or resistances.
Also seams to only have 0.19volts on the daughter board. Could this resistor be the problem? |
R23 is in the clock circuit which the MS-II doesn't use, as it has it's own crystal on the underside of the board.
|
Were should i be looking???????????
|
All times are GMT -4. The time now is 06:51 PM. |
© 2024 MH Sub I, LLC dba Internet Brands