|
MS3PRO vs AEM UEGO
hey guys, long time lurker here with a question. i got my ms3pro and my uego came not too long after. do i have to use the accessory port to wire the wideband into the ecu since the narrowband is only a single wire? which ports on the accesory plug would i have to use?
|
you can wire in through oe wiring or through the accessory port on back. your choice. documentation outlines both approaches, just read it and pick one
|
Do you have the AEM X series uego? That one has a positive and negative (ground) signal wire. I believe most other widebands just have a single signal wire.
That had me slightly confused when I installed my AEM X series. My OEM o2 plug is only one wire too. Therefore I just ran both signal wires to the options plug. Analog input and sensor ground, I think. I have the MS3 Pro PNP as well. |
Originally Posted by Artifex
(Post 1489556)
Do you have the AEM X series uego? That one has a positive and negative (ground) signal wire. I believe most other widebands just have a single signal wire.
That had me slightly confused when I installed my AEM X series. My OEM o2 plug is only one wire too. Therefore I just ran both signal wires to the options plug. Analog input and sensor ground, I think. I have the MS3 Pro PNP as well. |
i’ll be installing the ecu this weekend and just tuning narrowband for this week but next weekend i start turbo installation. the wideband looked very complicated and the factory o2 is 1 wire which had me a little confused. ill probably opt for using the accessory port so it will be direct and smooth. i need to look around and see how exactly to make the wideband talk to the ecu through the accessory port |
| All times are GMT -4. The time now is 02:23 AM. |
© 2024 MH Sub I, LLC dba Internet Brands